6647
Oil Separators 5mg/l with silt storage V100 without by-pass, in polyethylene, to 20 at 30l/s
This oil separator without by-pass with a silt storage are perfect to treating water form covered car parks, petrol station, garages. For washing areas, provide a complementary V200 silt storage to obtain a volume of V 300.
Reminder : the oil level alarm, additional piece of equipment, is mandatory unless special derogation from the local authorities.
The operation of the oil separator is based on the separation by density difference insoluble polluants contained in the runoff. Sludge compartment allows to settle and trap suspended solids (> 200 microns). Coalescence system with its large surface area allows free oil concentrate in promoting their collison. Oil then rise to the surface. The sealing system prevents the risk of the releasing of hydrocarbons.
- Designed in accordance with : EN 858-1 and EN 858-2
- Tank with 20 year anti-corrosion warranty
- Tested and held in a saline environment
- Resists on ground with a water table up to outlet level
- Low weight
- Easy handling
- Removable coalescence and easy maintenance
- Easy connections
- Devices held in stock
- Tank with 20 year anti-corrosion warranty
- Tested and held in a saline environment
- Resists on ground with a water table up to outlet level
- Low weight
- Easy handling
- Removable coalescence and easy maintenance
- Easy connections
- Devices held in stock
See sheet PHPE installation before handling and installing the separator.
Periodically to ensure that the ventilation is not obstructed. Frequency must be adapted to drain sludge volumes and hydrocarbon intercepted. It is recommended to drain the appliance when the sludge reaches 50% of the volume of the sludge or oil occupy 80% of the retention capacity of the separator (see NF P16-442). Enjoy the drain to clean the coalescence and the sealing system. After each discharge, the unit must be returned to water. Also check that the shutter fleet.