6649
Oil Separators 5mg/l with silt storage V100 and bypass
In this device, the silt storage permits to trap a suspension matter (sand, gravel..).
The oil separator with by-pass and silt storage are perfect to treating water from car parcks, highways.
Reminder : the oil level alarm, additional piece of equipment, is mandatory.
The operation of the oil separator is based on the separation by density difference insoluble polluants contained in the runoff. The by-pass system located at the entry box is used to regulate the flow (20% of treatment permissible flow). Sludge compartment allows to settle and trap suspended solids (>200um). Coalescence system with its large surface area allows free oil concentrate in promoting their collision. Oil then back to the closure system surface. The sealing system prevents the risk of the releasing of hydrocarbons
- Designed in accordance with : EN 858-1 and EN 858-2
- Tank with a 20 year anti-corrosion warranty
- Tested and held in a saline environment
- Resists on ground with water table up to outlet level
- Internal by-pass tube
- Low weight
- Easy handling
- Removable coalescence and easy maintenance
- Easy connections
- Devices held in stock
- Tank with a 20 year anti-corrosion warranty
- Tested and held in a saline environment
- Resists on ground with water table up to outlet level
- Internal by-pass tube
- Low weight
- Easy handling
- Removable coalescence and easy maintenance
- Easy connections
- Devices held in stock
Refer to the PHPE installation instructions before handling and installing the separator.
Maximum height of the water table = outlet water.
- PE buffer model: backfill without slab up to the PE buffer level (without extension). Mandatory protection tile if raised.
- Model with primers: protective concrete slab mandatory.
Periodically to ensure that the ventillation is not obstructed.
Frequency must be adapted to drain sludge volumes and hydrocarbon intercepted. It is recommended to drain the appliance when the sludge reaches 50% of the volume of the sludge or oil occupy 80% of the retention capacity of the seprator (see NF P16-442). Take advantage of the drain to clean the coalescence and sealing system. After each discharge, the unit must be returned to water. Also check that the shutter fleet.
Frequency must be adapted to drain sludge volumes and hydrocarbon intercepted. It is recommended to drain the appliance when the sludge reaches 50% of the volume of the sludge or oil occupy 80% of the retention capacity of the seprator (see NF P16-442). Take advantage of the drain to clean the coalescence and sealing system. After each discharge, the unit must be returned to water. Also check that the shutter fleet.